Forest Treeline Lower Side Graphics

🔧 Installation Instructions (Dry & Wet Methods)
🧊 Important: Install only when the temperature is between 50°F and 90°F. Avoid direct sunlight or installing on a hot surface. Make sure your surface is squeaky clean before starting!

🔹 DRY METHOD (Hinge Method – Recommended for Large Graphics)
Best for intermediate installers or those with help. Provides strong immediate adhesion.

You’ll need: Masking tape, squeegee (included), scissors or knife, a clean flat surface and a little patience

✅ Clean your surface thoroughly with rubbing alcohol or soap and water. No wax, grease, or dust. Ceramic coating does make it more difficult for graphics to adhere long term. Let it dry completely before installing.

🧽 On a flat surface, Lay the graphic face-up and use a squeegee to press down across the tape, ensuring all vinyl pieces are sticking to the transfer tape.

📍 Position the graphic on the vehicle and secure it in place with masking tape. Step back and double-check alignment.

🧷 Create a hinge by placing a vertical strip of masking tape down the center of the decal.

✂️ On one side, peel back the transfer tape and vinyl from the backing paper, cut off the backing, and slowly squeegee down the decal from the center hinge outward.

🔁 Repeat for the other side.

🕐 Wait 5-15 minutes, then peel the transfer tape off slowly at a 45° angle. If any pieces are not adhering to your vehicle, press them back down firmly and use more pressure from the squeegee.

🚫 If installed near the windshield or rear window, do not use wipers for at least 24 hours.

💧 WET METHOD (Beginner Friendly – but Requires Patience)
Gives you time to adjust placement. Great for solo installs but needs longer drying time.

You’ll need: Spray bottle with water + 1 drop of dish soap, squeegee (included), paper towels

✅ Clean the surface thoroughly with alcohol or soap and water, then dry.

💦 Peel back the backing paper and Spray the surface and sticky side of the decal lightly with your soapy water solution.

📍 Place the decal where you want it — the moisture lets you reposition as needed.

💪 Use the squeegee to press out water and air bubbles from the center outward. Be patient: firm, even pressure is key!

🕐 Wait at least 15-30 minutes, then carefully peel off the transfer tape at a 45° angle.

🚫 Do not drive the vehicle for at least 12 hours to allow the vinyl to fully bond and dry.

🚫 Do not use wipers for 24 hours if applied to glass.

⚠️ Additional Notes & Disclaimer:
If you're not sure which method to use, or you’re new to decal installs, reach out before installing — we’re happy to help!

Most local tint or wrap shops will install graphics for a small fee if you’d prefer professional installation.

We are not responsible for any mishaps during installation. Take your time and read all instructions before starting.

Let the decal cure for at least 24 hours before washing the vehicle or using high-pressure water.